Start While validating that device serial1 was really a serial port

While validating that device serial1 was really a serial port

Don’t see yours, it is easy to write an adapter and we are here to help you.

Literally all requested automation controllers are currently supported and the list continues to expand…

Please note that if you want to use the ethernet module, you need to raise the socket as much as possible above the board while soldering it, as the ethernet jack on board the ethernet module is slightly higher than the pinheaders on the board.

The standard Gateway W5100 example under My Sensors in the Arduino IDE, is compatible with the Sensebender Gateway, and can be run without problems.

For details on how to add these board definitions, you should go here.

In addition you need to install Arduino SAMD board files which are installed from the Arduino Boards Manager.

After installing the board definitions, choose as your target platform, this will probably be the last board in the list shown by Arduino IDE.

Also, you will want to make sure you are using the My Sensors libraries v2.2.0 or newer.

In addition, the Gateway includes a micro-sd card reader for Io T applications where additional local non-volatile storage is required (e.g.